This video covers how to route multiple channels of audio from the Maschine 2.0 plugin into Logic Pro X
This is useful if you want to route individual drums out into Logic for mixing and you wish to use Logic fx on individual sounds from Maschine.
You can also do this with entire groups if you wish, if you want a whole kit to have the same effect or maybe you have a group of chops you want to treat as a whole in Logic.
No matter what you want to do, this video will show you how to setup the routing.
If you have any questions, just ask!
*access instantly when you join today!
Thank you for that sir much appreciated.
If you don’t mind could you do a tutorial on routing midi channels from maschine as a plugin inside of LPX.
What I want to do is created a new template that I can load from LPX that will auto load Maschine 2 and have all the audio and midi channels pre-routed. I want to trigger the sounds from maschine 2 via midi inside the daw. This probably sounds complicated but there’s a method behind the madness.
Thanks man. You want Maschine 2 to be in controller mode while in Logic right?
Yes. The cool part is when I do this template I’ll be able to hit the pads on the controller but have the midi notes recorded in Logic. And of course on playback the midi data will trigger the maschine sounds. I can arrange a lot better in LPX than in maschine. In other words I’d like to be able to triggers sounds as if I had Ultrabeat loaded. Also in this template it load as a track stack.
I m also waiting for a video showing how to use machine 2 in logic X (midi) . I only found a video for the older Maschine 1.8 .and the old logic.
Thanks a lot
Thank you very much knock I needed this. How do i go about routing my maschine’s sounds through my pair of api 512c’s (micpres)? I wanna run maschine’s sounds through my analog gear.
What is your audio interface setup ? (What Audio interface do you use)
I have an apogee symphony 64 system with an AD/DA 16x and DA/AD 16x convertors (16 inputs and 16 outputs)
I have a API lunchbox with 2 512c’s in them.
I am working on finding out now bro..will have a vid soon
are you using a ssd HD?
hot shit Knock. thnx i recorded my first joint today using this method. came out great. thank you.
Thats what I like to hear fam !!
Great vid., so after the routing of it all how do you go about “printing” those individual tracks? All on their own channel? In real time?
Check this vid: https://maschinetutorials.com/maschine-2-0-tracking-out-audio-in-logic-pro-x-in-realtime/
When I route the audio to Logic, my side-chain compression that was done in Maschine is gone (as well as other effects), and no sc compression happens in Logic… do you know why that is?
That’s because you are no longer routing within Maschine where the sidechain and FX are happening, you’re routing the signal externally. Unless you were using insert fx on your sounds, they will no longer be going through the fx. You would have to setup the sidechain and fx in Logic in that case.
That makes sense! The compressor was on the group of sounds, and when routed externally the sounds weren’t going through the comp. I’ll give “insert fx” a shot.
Cool
why isn’t any of this recording
I don’t know, depends on what you’ve setup. If no audio is recording then either you haven’t routed the audio properly or your audio tracks are not record enabled.